Login
Contents x
Installation
  • 01 May 2024
  • Dark
    Light
  • PDF
Contents

Installation

  • Updated on 01 May 2024
  • Dark
    Light
  • PDF
Article Summary

Perform the following steps to install the IAP software onto a target server. Be sure the latest version of the IAP package has been copied to the server. You can acquire the link for this build from the portal.

ⓘ Note - OS Support

For a list of supported server operating systems, refer to the Itential Dependencies page.

Installation

Perform the following steps to install IAP onto the server.

  1. Transfer the IAP binary package to the server.

  2. Change to directory, cd, where the package is stored.

  3. Set permissive mode and run the install binary as a privileged user. The default installation directory is /opt/pronghorn/current.

    sudo setenforce permissive
sudo bash itential-<build-id>_<version>.linux.x86_64.bin -i

ⓘ Note - Installer Version

Change <build-id> and <version> in the installer binary above to match the version being installed.

Was this article helpful?
What's Next
Privacy Policy
Cookie Policy
Terms of Use
EULA
Copyright © 2022 Itential for Developers
Change password!
Changing your password will log you out immediately. Use the new password to log back in.
Change profile
Success!
First name must have atleast 2 characters. Numbers and special characters are not allowed.
Last name must have atleast 1 characters. Numbers and special characters are not allowed.
Enter a valid email
Enter a valid password
Your profile has been successfully updated.
Logout